Flipper Zero Hacker Edition Controller
Flipper Zero is a kind of Tamagotchi: on the screensaver there is a dolphin with a name, mood and level of development. After each user action, the pet gains experience, increases its level and gives funny comments. What's inside Flipper Zero: STM32 microcontroller with 80 MHz frequency and 128 KB SRAM memory; 12 dBm TX radio module that operates at frequencies of 300-348MHz, which is a wide range and covers most devices. Buzzer with 87 dB sound output; Bluetooth 5.0 with a data transfer rate of 2 Mbit/s; Supports 4 GB MicroSD memory cards; RFID with a frequency of 125 kHz; Infrared transmitter with TX/RX range 800-950 nm and TX power 3 mW; NFC with the ability to read, write and emulate ISO-14443 cards. Dimensions 98 x 39 x 24 mm, weight 140 grams. The device is equipped with a 1.4-inch monochrome LCD display with a resolution of 128×64 px. The LiPo 2000mAH battery can last about 7 days.
- Microcontroller: Model: STM32WB55RG ARM Cortex-M4 32-bit 64 MHz (application processor) ARM Cortex-M0+ 32 MHz (network processor) Flash memory: 1024 KB SRAM: 256 KB
- USB: 1 USB 2.0 Type C port for charging USB devices
- GPIO: 3.3 Level CMOS Input Signal, 5V Tolerant Up to 20mA per digital pin
- Display: LCD monochrome Resolution: 128x64 pixels Controller: ST7565R Interface: SPI Diagonal size: 1.4 inches
- Battery: LiPo 2000 mAh approximately 7 days
- Sub-1 GHz Module: Chip: TI CC1101 Transmitter Power: 0 dBm max. Frequency bands (depending on your region): 315 MHz, 433 MHz, 868 MHz, 915 MHz
- NFC: Frequency: 13.56 MHz Supported cards:, ISO-14443A/B, NXP Mifare® Classic/Ultralight/DESFire, etc., FeliCa™, NFC Forum protocols
- RFID 125 kHz: Frequency: 125 kHz Modulation: AM, PSK, FSK Supported cards: EM400x, EM410x, EM420x, HIDProx, Indala
- Bluetooth LE 5.0: Transmission power: 0 dBm max. Reception sensitivity: -96 dBm Data transfer rate: 2 Mbps
- Micro SD: Up to 64 GB MicroSDHC Read/write speed: up to 5 Mbps
- Buzzer: Frequency: 100-2500 Hz. Sound output: 87 dB. Type: coin.
- Vibration motor: Force value: 30 N Speed: 13500 rpm
- Infrared: TX/RX range: 800-950 nm Transmission power: 300 mW
- iButton 1-Wire: Operating modes: read/write/emulator Supported protocols:, Dallas DS1990A, CYFRAL
- Controls: Joystick with 5 buttons Back button Reboot - Back and Left buttons for 2 seconds
- Physical: Size: 100 x 40 x 25 mm Weight: 102 grams Shell materials: PC, ABS, PMMA Operating temperature: 0 ~ 40 °C
- Color: white