Conductivity electrode OHAUS Starter STCON3
Conductometric electrode OHAUS Starter STCON3. The conductivity electrode STC0N3 has a built-in temperature sensor. The STCON3 uses a 4-electrode potentiometric method for measuring conductivity, in which four stainless steel electrodes are located on the sensor body. This completely eliminates polarization. A non-polarizing sensor allows conductivity to be measured over a wider range because its performance is not affected by electrolysis. Terms of use: During the measurement process, a protective plastic housing must be installed on the sensor. The level of the analyzed solution should be above the mark on the plastic case and below the ventilation hole. After each measurement, the sensor must be washed with distilled water to avoid cross-contamination of the analyzed solutions. There must be no air bubbles in the measuring cell during the measurement process. When measuring samples at different temperatures, take readings only after reaching thermal equilibrium. It is recommended to determine the moment when the readings are established manually. Manba: https://www.nv-lab.ru/catalog_info.php?ID=4432
- Measuring range: 2-200 µS/cm;
- 0-50 °C
- Net weight, g: 85
- Cable, m: 1.1
- Dimensions, mm: 15
- Electrode Type: Conductivity
- Rod material: Plastic